All Butter Pie Crust for Pies and Tarts (Pâte Brisée)

1. Stage

Combine the flour, salt, and sugar: Place the flour, salt, and sugar into a food processor and pulse until well combined.

2. Stage

Add the butter, half at a time: Add half of the butter cubes and pulse 8 times. Then add the other half of the butter cubes and pulse 6 more times. You should have a mixture that resembles a coarse meal, with many butter pieces the size of peas.

3. Stage

Slowly add ice water: Add two tablespoons of ice cold water (without the ice!) to the food processor bowl and pulse several times. Then add more ice water, slowly, a teaspoon at a time, pulsing several times after each addition, until the mixture just barely begins to clump together. If you pinch some of the crumbly dough and it holds together, it's ready, if not, add a little more water and pulse again. Try to keep the water to a minimum. Too much water will make your crust tough.

4. Stage

(Optional) Press the dough a few times to flatten some of the butter for a more flaky crust: Remove the crumbly mixture from the food processor and place on a very clean, smooth surface. If you want an extra flaky crust, you can press the heel of your palm into the crumbly mixture, pressing down and shmooshing the mixture into the table top. This is a French technique, called "fraisage". Do this a few times, maybe 4 to 6 times, and it will help your crust be extra flaky.

5. Stage

Form dough into a disk, wrap, and chill: Then, use your hands to press the crumbly dough together and shape into a disk. Work the dough only enough to just bring the dough together. Do not over-knead or your crust will end up tough. You should be able to see little bits of butter, speckling the dough. When these bits of butter melt as the crust cooks, the butter will help separate the dough into flaky layers. So, visible pieces of butter are a good thing, what you are aiming for, in the dough. Sprinkle the disc with a little flour on all sides. Wrap the disc in plastic wrap and refrigerate at least 1 hour.

6. Stage

Remove from refrigerator and let sit for a few minutes: When you are ready to roll out the dough, remove the disk from the refrigerator and let it sit for 10 to 15 minutes to take enough of a chill off of it so that it becomes easier to roll out. While the dough disk is still wrapped in plastic, warm the edges with your hands. If there are any cracks in the dough, massage them to close them.

7. Stage

Roll out the dough: Place the dough disk on a lightly floured, clean flat surface. Sprinkle some flour on top of the disk. If the dough is a bit stiff, use your rolling pin to press down on the center a few times. No need to be gentle at this point. You're trying to shock the chilled butter in the dough to loosen up a bit. Roll out the dough to a 12-inch circle, to a thickness of about 1/8-inch thick. As you roll out the dough, check if the dough is sticking to the surface below. Add a few sprinkles of flour if necessary to keep the dough from sticking.

8. Stage

Line a pie or tart pan: Carefully fold the dough in half, then transfer it to a 9-inch pie plate or tart pan, lining up the fold with the center of the pan. Gently unfold and press down to line the pie dish with the dough. With a pair of kitchen scissors or a knife, trim the overhanging dough to about 1/2 inch. Fold the overhang under along the edge of the pie dish. Crimp the edge of the pie crust, using your fingers in a pinching motion, or the tines of a fork. Freeze until ready to bake. To cook the pie crust, follow the directions for the pie you are making. If you would like to pre-bake the crust, see our directions on how to blind-bake a pie crust . Did you love the recipe? Give us some stars and leave a comment below!